LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Lighting Systems) >> Repair Instructions >> Tail Lamp Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the tail lamp assembly.
  2. Connect the tail lamp electrical connector
    3. Fig 1: View Of Tail Lamp
    GM1287389Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the nuts (1) that secure the tail lamp (2) to the body.

    Tighten:  Tighten the tail lamp nuts to 6 N.m (53 lb in).

  4. Install the rear seat belt retractor. Refer to Seat Belt Retractor Replacement - No. 2 Rear .
  5. For the right side only, install the rear speaker. Refer to Radio Rear Speaker Replacement (Console Cover) or Radio Rear Speaker Replacement (Upper Pillar) or Radio Rear Speaker Replacement (Outer) .
  6. For the left side only, install the auxiliary blower motor. Refer to Auxiliary Blower Motor Replacement .
  7. For the left side only, install the liftgate close actuator motor control module. Refer to Liftgate Close Actuator Motor Control Module Replacement .
  8. Install the body side rear trim panel. Refer to Body Side Rear Trim Panel Replacement (w/ TB5) or Body Side Rear Trim Panel Replacement (w/o TB5) .
  9. Close the liftgate.
scientia non olet · About LEMON Manuals