LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> XLR Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.6L (LH2) - Introduction >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Throttle Body Assembly
    GM927998Courtesy of GENERAL MOTORS CORP.
  1. Install a new throttle body gasket into the groove on rear side of throttle body. Be sure gasket upper and lower tabs (1) are aligned to the throttle body properly.
  2. Install the throttle body assembly to the water outlet.
    3. NOTE: Refer to Fastener Notice .
    IMPORTANT: Always use a torque wrench in order to obtain the proper torque.
  3. Install the throttle body attaching bolts.

    Tighten:  Tighten the throttle body bolts to 10 N.m (89 lb in).

  4. Connect the throttle body assembly electrical connector.
    5. Fig 2: View Of Air Intake Duct & Throttle Body
    GM1252539Courtesy of GENERAL MOTORS CORP.
  5. Install the air intake duct (1).
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  7. Connect the mass air flow (MAF) sensor electrical connector.
scientia non olet · About LEMON Manuals