LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing & Installing Stabilizer Shaft Link Retaining Nut
    GM750841Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Apply threadlocker 242 or equivalent to the threads of the stabilizer shaft link.
  1. Install the stabilizer shaft link.
    2. NOTE: Refer to Fastener Notice .
  2. Install the stabilizer shaft link retaining nuts.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

    3. Fig 2: Identifying ABS Sensor Wiring Harness At The Stabilizer Shaft Links
    GM746681Courtesy of GENERAL MOTORS CORP.
  3. Connect the ABS sensor wiring harness to the stabilizer shaft link.
  4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals