LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> STS V >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.4L - Introduction >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Remove the closeout/insulator panel from under the dashboard on the drivers side. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
    2. Fig 1: View Of APP Sensor Bracket Mounting Nuts
    GM818887Courtesy of GENERAL MOTORS CORP.
    NOTE: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.
  2. Disconnect the accelerator pedal position (APP) sensor electrical connector from the accelerator pedal module.
  3. Remove the APP sensor mounting bolts.
  4. Remove the APP sensor from the vehicle.
  5. If necessary, remove the nuts from the APP sensor bracket and remove the bracket from the front of dash.
scientia non olet · About LEMON Manuals