LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade EXT >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Data Communication System >> Diagnostic Information and Procedures >> DTC U1862 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector X2 at the SDGM.
    2. IMPORTANT: The scan tool must be disconnected and the ignition key must be out of the ignition switch for 30 seconds for proper test results.
  2. Test for less than 10 ohms between the ground circuit terminal 18 and B+.
    • If greater than the specified range, test the circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 8 and ground.
    • If the test lamp does not illuminate, test the circuit for a short to ground or an open/high resistance.
  4. Ignition ON, verify that a test lamp illuminates between the enable signal circuit terminal 16 and ground.
    • If the test lamp does not illuminate, test the circuit for an open/high resistance.
  5. If all circuits test normal, replace the SDGM.
scientia non olet · About LEMON Manuals