LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> STS V >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Column Trim Covers Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Upper Steering Column Trim Cover & Screws
    GM588304Courtesy of GENERAL MOTORS CORP.
  1. Install the upper steering column trim cover (1) to the closeout shroud (3).
  2. Install the upper trim cover (1) to the steering column.
    3. NOTE: Refer to Fastener Notice .
  3. Install the retaining screw to the upper trim cover.

    Tighten:  Tighten the screw to 1.5 N.m (13 lb in).

  4. Install the Ignition lock cylinder.
    5. Fig 2: View Of Closeout Shroud, Lower Steering Column Trim Cover & Retaining Screws
    GM588300Courtesy of GENERAL MOTORS CORP.
  5. Install the lower steering column trim cover and ensure that the tabs (2) on the lower trim engage with the tabs on the upper trim cover. Snap the covers together.
  6. Connect the lower trim cover to the closeout shroud.
  7. Install the retaining screws to the lower trim cover.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

    8. NOTE: Avoid damaging the steering column electronic lock harness by gently removing the plugs installed in the I/P beam. Do NOT twist, pull, bend, cut, or incorrectly route the harness. Damage to the harness will require replacement of the entire electronic lock.
  8. Install the knee bolster. Refer to Knee Bolster Replacement .
  9. Install the steering wheel. Refer to Steering Wheel Replacement .
  10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  11. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals