LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> STS Base, 4.6 A, AWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Replacement (LY7) >> Installation Procedure

Installation Procedure

  1. Install the power steering pump to the power steering pump bracket. Refer to Power Steering Pump Bracket Replacement (LH2)  or Power Steering Pump Bracket Replacement (LY7) .
    2. Fig 1: View Of Power Steering Bracket Bolts
    GM888286Courtesy of GENERAL MOTORS CORP.
  2. Install the power steering pump with bracket to the vehicle.
    3. NOTE: Refer to Fastener Notice .
  3. Install the power steering pump bracket to the engine mounting bolts (1, 2 and 3).

    Tighten:  Tighten the bolts in sequence to 50 N.m (37 lb ft).

  4. Connect the power steering pressure hose to the power steering pump.
    5. Fig 2: Identifying Power Steering Reservoir Outlet Hose
    GM1300041Courtesy of GENERAL MOTORS CORP.
  5. Connect the power steering reservoir outlet hose to the power steering pump.
  6. Remove the drain pan from under the vehicle.
  7. Install the power steering pulley. Refer to Power Steering Pulley Replacement .
  8. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement for the 3.6L engine.
  9. Bleed the power steering system. Refer to Power Steering System Bleeding .
  10. Install the front air deflector. Refer to Front Air Deflector Replacement .
scientia non olet · About LEMON Manuals