LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> STS Base, 4.6 A, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls And Fuel - 4.4L - DTC P0010 To DTC P0158) >> DTC P0033 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the SCB solenoid.
  2. Ignition ON, verify that a test lamp illuminates between the ignition supply circuit and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  3. Connect a test lamp between the control circuit and the ignition supply circuit.
  4. Engine running, command the SCB solenoid duty cycle from 0 percent to 90 percent with a scan tool. The test lamp should change brightness when incrementing between the commanded states.
    • If the test lamp remains ON all the time, test the control circuit for a short to ground. If the circuit tests normal, replace the ECM.
    • If the test lamp remains OFF all the time, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test the SCB solenoid. Refer to Component Testing for instructions.
scientia non olet · About LEMON Manuals