LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> STS Base, 4.6 A, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Front Drive Axle) >> Repair Instructions >> Front Axle Lubricant Replacement >> Filling Procedure

Filling Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drain plug to the differential.

    Tighten:  Tighten the differential drain plug to 39 N.m (29 lb ft).

    NOTE: Refer to Fastener Notice .
    Fig 1: Identifying Differential Drain Plug
    GM912464Courtesy of GENERAL MOTORS CORP.
  2. Clean any dirt from around the differential fill plug.
    Fig 2: Identifying Differential Fill Plug
    GM912461Courtesy of GENERAL MOTORS CORP.
  3. Remove the fill plug from the differential.
  4. Fill the differential with 75W90 synthetic axle lubricant, GM P/N 12378261 (Canadian P/N 10953455) or equivalent. Refer to Approximate Fluid Capacities .
  5. Inspect the gear lubricant level to ensure it is even with the bottom of the fill plug hole to no lower than 6 mm (0.25 in) below the opening.
  6. Install the fill plug to the differential.

    Tighten:  Tighten the fill plug to 39 N.m (29 lb ft).

  7. Lower the vehicle.
scientia non olet · About LEMON Manuals