Installation Procedure

Position the battery positive cable to the engine.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

Fig 1: View Of Starter Terminal Nut & Battery Positive Cable

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Connect the battery positive cable (2) to the starter and install the starter terminal nut (1).
Tighten: Tighten the nut to 13 N.m (115 lb in).

Fig 2: View Of Battery Positive Lead & Generator BAT Terminal Nut

Courtesy of GENERAL MOTORS CORP.

Connect the battery positive lead (2) to the generator and install the generator BAT terminal nut (3).
Tighten: Tighten the nut to 13 N.m (115 lb in).
Install the protective boot to the generator output BAT terminal.
Lower the vehicle.

Fig 3: Identifying Battery Positive Cable To Underhood Fuse Block

Courtesy of GENERAL MOTORS CORP.

Install the nut (1) securing the battery positive cable (2) to the underhood fuse block.
Tighten: Tighten the nut to 15 N.m (11 lb ft).

Fig 4: View Of Underhood Fuse Box

Courtesy of GENERAL MOTORS CORP.

Fig 5: View Of Battery Positive & Negative Cables

Courtesy of GENERAL MOTORS CORP.

Connect the battery positive cable to the battery.
Tighten: Tighten the bolt to 17 N.m (13 lb ft).
Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .