LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Brake Fluid Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Brake Fluid Pressure Sensor & Electrical Connector
    GM773022Courtesy of GENERAL MOTORS CORP.
  1. Install the brake fluid pressure sensor (2) to the EBCM (1).

    Tighten:  Tighten the brake fluid pressure sensor to 17 N.m (13 lb ft).

  2. Connect the brake fluid pressure sensor electrical connector (3) to the brake fluid pressure sensor (2).
  3. Fill and bleed the hydraulic brake system. Refer to Master Cylinder Reservoir Filling and Hydraulic Brake System Bleeding (Manual) in Hydraulic Brakes.
  4. Perform the Auto Bleed Procedure. Refer to Antilock Brake System Automated Bleed Procedure .
  5. Perform the Diagnostic System Check - Vehicle. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals