Installation Procedure

If the windshield reveal molding retainer clips are bent or damaged, replace the clips.
Align the top end of the reveal molding to the end cap tongue inside the opening of the roof rail.
Install the reveal molding downward and align the reveal molding with the screw holes.

Fig 1: Reveal Molding

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the reveal molding screws.
Tighten: Tighten all of the screws to 2 N.m (18 lb in).
Remove the masking tape.
Clean the tape residue from the windshield.