LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> SRX 3.6 7, AWD >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Replacement (LH2) >> Installation Procedure

Installation Procedure

  1. Install the power steering pump to power steering bracket. Refer to Power Steering Pump Bracket Replacement (LH2)  or Power Steering Pump Bracket Replacement (LY7) .
    NOTE: Refer to Fastener Notice .
  2. Install the power steering pump with bracket to the vehicle.
    3. Fig 1: View Of Power Steering Pump
    GM888277Courtesy of GENERAL MOTORS CORP.
  3. Install the power steering bracket to the engine bolts.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

    4. Fig 2: View Of Power Steering Pump-To-Engine Mounting Bolt
    GM888275Courtesy of GENERAL MOTORS CORP.
  4. Install the power steering pump to the engine mounting bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  5. Connect the power steering pressure hose to the power steering pump.
    6. Fig 3: View Of Power Steering Reservoir Outlet Hose
    GM888270Courtesy of GENERAL MOTORS CORP.
  6. Connect the power steering reservoir outlet hose to the power steering pump.
  7. Clean off any excess fluid from the vehicle.
  8. Remove the drain pans from under the vehicle.
  9. Install the front air deflector. Refer to Front Air Deflector Replacement .
  10. Install the power steering pulley. Refer to Power Steering Pump Pulley Replacement .
  11. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  12. Bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals