LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1638 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Knuckle
    GM1869837Courtesy of GENERAL MOTORS CORP.
  1. Install the lower ball joint in the knuckle. Refer to Lower Control Arm Replacement (2500, 3500)  or Lower Control Arm Replacement (2500)  or Lower Control Arm Replacement (1500) .
  2. Install upper ball joint in the knuckle. Refer to Upper Control Arm Replacement (2500, 3500)  or Upper Control Arm Replacement (1500) .
  3. Install the outer tie rod end in the knuckle. Refer to Steering Linkage Outer Tie Rod Replacement .
  4. Install the wheel bearing and hub assembly. Refer to Front Wheel Hub, Bearing, and Seal Replacement (2500)  or Front Wheel Hub, Bearing, and Seal Replacement (1500) .
  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  6. Remove the support and lower the vehicle.
  7. Verify the wheel alignment. Refer to Wheel Alignment Specifications .
scientia non olet · About LEMON Manuals