LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2007 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1384 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Replacement (2500) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Lower Control Arm Components
    GM1870076Courtesy of GENERAL MOTORS CORP.
  1. Install the lower control arm (4).
  2. Install the lower control arm bolts (3).
  3. Install the washers (2).
    4. CAUTION: Refer to Fastener Caution .
  4. Install the lower control arm retaining nuts (1) and tighten to 175 N.m (129 lb ft).
  5. Install the lower ball joint into the steering knuckle.
    6. Fig 2: View Of Lower Ball Joint Retaining Nut
    GM830506Courtesy of GENERAL MOTORS CORP.
  6. Install the NEW lower ball joint retaining nut and tighten to 125 N.m (92 lb ft).
  7. Install the wheel drive shaft. Refer to Wheel Drive Shaft Replacement (2500) or Wheel Drive Shaft Replacement (1500) .
  8. Install the shock absorber. Refer to Shock Absorber Replacement (2500 Series) .
  9. Install the torsion bars. Refer to Torsion Bar and Support Assembly Replacement (Bushing Style)  or Torsion Bar and Support Assembly Replacement (Link Style) .
  10. Remove the support for the knuckle and upper control arm.
  11. Install the stabilizer shaft link to the lower control arm. Refer to Stabilizer Shaft Replacement (1500)  or Stabilizer Shaft Replacement (2500, 3500) .
  12. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  13. Remove the supports and lower the vehicle.
  14. Verify the front end alignment. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals