Rear Camber Adjustment

Tools Required 

J 45845  Caster and Camber Adjusting Tool. See Special Tools .

Fig 1: Installing J 45845
Courtesy of GENERAL MOTORS CORP.
1. Install J 45845  to the lower control arm and the frame. See Special Tools .
2. Loosen the lower control arm to frame bolt.
NOTE: Refer to Fastener Notice .
3. Adjust the camber angle by turning the turnbuckle on J 45845  until the specifications have been met. See Special Tools .

   Tighten:  Tighten the bolt to 150 N.m (111 lb ft).

4. Verify that the camber is still with specifications. Refer to Wheel Alignment Specifications .
5. Adjust the rear toe. Refer to Rear Toe Adjustment .