LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Body Rear End) >> Repair Instructions >> Liftgate Applique Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the license plate applique wire harness through the opening in the liftgate. Install the grommet in the opening.
  2. Install the license plate applique to the liftgate and handle assembly. Press on the license plate applique to engage the retaining clips to the handle assembly.
  3. Verify that the license plate applique harness is not pinched between the liftgate and the studs.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the five nuts that retain the license plate applique assembly to the liftgate. Install the nuts in the following order:
    1. The center stud
    2. The top two studs
    3. The bottom two studs
      IMPORTANT: Tighten the nuts in two stages. First, tighten until snug. Then tighten to the specification.

      Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  5. Connect the license plate applique harness connector to the liftgate harness connector. Install the plastic retainer.
  6. Verify the proper operation of the license plate light and the backup lights.
  7. Connect the courtesy light connector to the liftgate wiring harness connector.
  8. Align the outboard locators and the retaining clips located about the middle of the trim panel. Press the clips into position.
  9. Align the two lower fasteners and press them into position. The fasteners are located on the left and the right sides.
    IMPORTANT: Ensure that the fasteners are aligned with the correct groove.
  10. Align the remaining fasteners. Begin with the lower fasteners, then alternate from side to side.
    IMPORTANT: Ensure that the fasteners are aligned with the correct groove.
    IMPORTANT: A sharp blow may be necessary to properly seat the fasteners.
  11. Align the remaining clips on the lower portion of the trim panel. Press the clips into position.
  12. Install the screw in the pull cup.
scientia non olet · About LEMON Manuals