LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> XLR Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Entertainment System) >> Diagnostic Information and Procedures >> Diagnostic System Check - Entertainment System >> Test Description

Test Description

WARNING: This page is about a different car, the 2004 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
  2. 4:  Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
  3. 6:  The symptom list in Symptoms will determine the correct diagnostic procedure to use.
  4. 7:  The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
Diagnostic System Check - Entertainment System

Step Action Yes No
1
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
Does the scan tool power up?		 Go to Step 2  Go to Scan Tool Does Not Power Up in Data Link Communications
2  Attempt to establish communication with the following:
  • Amplifier
  • Radio
  • CDX/DVD (U2V or U2X)
  • Dash Integration Module (DIM)
  • Digital Radio Receiver (DRR), if equipped
  • Driver antenna module.

Does the scan tool communicate with all devices present?		 Go to Step 3  Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications
3 Is the vehicle equipped with rear seat entertainment RPO U42? Go to Step 4  Go to Step 5 
4  Use the scan tool class 2 message monitor to communicate with the disc player and video display (DPVD).
Does the scan tool communicate with the DPVD?		 Go to Step 5  Go to Scan Tool Does Not Communicate with Class 2 Device
5
IMPORTANT: The engine may start during the following step. Turn OFF the engine as soon as you have observed the Crank power mode.
  1. Access the Class 2 Power Mode in the Diagnostic Circuit Check on the scan tool.
  2. Rotate the ignition switch through all positions while observing the Ignition Switch Power Mode parameter.
Does the Ignition Switch parameter reading match the ignition switch position for all switch positions?		 Go to Step 6  Go to Power Mode Mismatch in Body Control System
6  Select the following display DTC functions on the scan tool:
  • Radio
  • Dash Integration Module (DIM)
  • Digital Radio Receiver (DRR), if equipped

Does the scan tool display any DTCs?		 Go to Step 7  Go to Symptoms - Entertainment 
7  Does the scan tool display any DTCs which begin with a "U"? Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications Go to Step 8 
8 Does the scan tool display DTC B1000, B1004, B1007, or B1009? Go to Diagnostic Trouble Code (DTC) List in Body Control Systems Go to Step 9 
9 Does the scan tool display DTC B1327? Go to Diagnostic Trouble Code (DTC) List in Engine Electrical Go to Diagnostic Trouble Code (DTC) List 
scientia non olet · About LEMON Manuals