Removal Procedure
WARNING: This page is about a different car, the 2004 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- Open the liftgate.
- Remove the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate in Body Rear End.
- Remove the rear wiper motor. Refer to Wiper Motor Replacement - Liftgate in Wipers/Washer Systems.
- Disconnect the rear window defogger connector.
- Cover to protect the following parts from broken glass:
- Upper dash pad
- Defroster outlets and A/C outlets
- Seats and carpeting
- Separate the urethane adhesive from the window.
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clear water.
- UseJ 24402-A , J 39032 or equivalent in order to remove the window. See Special Tools and Equipment .
- With the aid of an assistant, use the suction cups in order to lift the liftgate window (2) from the opening.
CAUTION:
If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
IMPORTANT:
Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim.
CAUTION:
If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
CAUTION:
Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.
IMPORTANT:
Keep the cutting edge of the tool against the window.