LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 522 (Interior Trim System And Paneling) >> Repair Instructions >> Sunshade Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the sunshade to the headliner.
    2. Fig 1: Electrical Connector
    GM708358Courtesy of GENERAL MOTORS CORP.
  2. Push the electrical connector and the wiring through the hole in the headliner.
  3. Connect the electrical connector (1).
  4. Position the plastic retainer (2) over the top of the electrical harness.
  5. Align the fasteners to the holes in the sunshade metal integral clip (2).
    6. Fig 2: Sunshade & Outboard Bezel
    GM734901Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: Do not pinch the wiring (3) when you install the fasteners.
  6. Install the fasteners that secure the bezel (2) to the headliner and tighten to 2 N.m (18 lb in).
  7. Install the windshield pillar garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .
  8. Secure the sunshade to the sunshade rod retainer.
scientia non olet · About LEMON Manuals