Installation Procedure
WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- If replacing the mode actuator, transfer the lever from the old actuator to the new actuator.
- Install the mode actuator.
- Install the mode actuator screws.
Tighten: Tighten the screws to 1 N.m (9 lb in).
- Connect the electrical connector to the actuator.
- Install the I/P carrier. Refer to Instrument Panel Carrier Replacement (Left Hand Drive) or Instrument Panel Carrier Replacement (Right Hand Drive) .
NOTE:
Refer to Fastener Notice
.