LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS V >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Power Door Lock System And Release Systems) >> Repair Instructions >> Front Side Door Latch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rod Guide, Lock Knob Rod, & Door Latch Screws
    GM788020Courtesy of GENERAL MOTORS CORP.
  1. Install the inside door handle rod and lock rod to the door latch.
  2. Install the electrical connector.
  3. Install the door latch into the door.
  4. Install the lock cylinder rod to the door latch.
    5. NOTE: Refer to Fastener Notice .
  5. Install the door latch screws (3).

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

    6. Fig 2: Installing Rod Retainer Clip
    GM105412Courtesy of GENERAL MOTORS CORP.
  6. Install the outside door handle rod (1) into the latch clip (2).
  7. Close the clip.
    8. Fig 3: View Of Rod Guide, Lock Knob Rod, & Door Latch Screws
    GM788020Courtesy of GENERAL MOTORS CORP.
  8. Install the lock knob rod into the rod guide (2).
  9. Install the inside handle rod into the rod guide (1).
  10. Inspect for the proper operation of the door handles, lock cylinder, and door latch.
  11. Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
  12. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals