Circuit/System Verification
- Verify the integrity of the MAP sensor system by inspecting for the following conditions:
- Any damage to the MAP sensor housing
- Any damage to the MAP sensor seal
- A loose or improperly installed MAP sensor
- A restriction in the vacuum source of the MAP sensor
- Ignition ON, observe the scan tool MAP, SC Inlet Pressure, and BARO sensor parameters. The readings should be within 5 kPa of each other and also the current BARO for your location. Refer to Altitude Versus Barometric Pressure .
- Engine running, observe the DTC information with a scan tool. DTCs P0107 or P0108 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.