LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS V >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Repair Instructions >> Brake Pressure Modulator Valve Replacement >> Removal Procedure

Removal Procedure

CAUTION: For safety reasons, the brake pressure modulator valve assembly must not be repaired, the complete unit must be replaced. With the exception of the EBCM, no screws on the brake pressure modulator valve assembly may be loosened. If screws are loosened, it will not be possible to get the brake circuits leak-tight and personal injury may result.
  1. Turn OFF the ignition.
    2. IMPORTANT: The area around the electronic brake control module (EBCM) must be free from loose dirt to prevent contamination of disassembled ABS components.
  2. Thoroughly clean all contaminants from around the EBCM.
    3. CAUTION: Brake fluid may irritate eyes and skin. In case of contact, take the following actions:
    • Eye contact-rinse thoroughly with water.
    • Skin contact-wash with soap and water.
    • If ingested-consult a physician immediately.
    NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Cautions and Notices.
    Fig 1: View Of BPMV & Brake Pipes
    GM772876Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Record the location of all brake pipes to the brake pressure modulator valve (BPMV) for use as an aid during installation.
  3. Remove the 2 master cylinder brake pipes (3) from the BPMV (1).
  4. Clean any brake fluid spillage from the BPMV (1).
  5. Raise and support vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  6. Remove the air deflector shield. Refer to Front Air Deflector Replacement in Body Front End.
  7. Remove the wheelhouse liner. Refer to Front Wheelhouse Liner Replacement in Body Front End.
    8. IMPORTANT: It is not necessary to remove the washer solvent container from the vehicle.
  8. Remove the washer solvent container bracket. Refer to Solvent Container, Pump, Level Sensor Replacement - Windshield Washer in Wipers/Washer Systems.
  9. Remove the 4 wheel brake pipes (2) from the BPMV (1).
    10. NOTE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
  10. Press the retainer on the EBCM electrical connector (1).
    11. Fig 2: View Of EBCM And Electrical Connector
    GM899234Courtesy of GENERAL MOTORS CORP.
  11. Rotate the EBCM connector tab (2) forward to the unlocked position.
  12. Disconnect the EBCM electrical connector (1) from the EBCM and position out of the way.
  13. Remove the front BPMV bracket nuts.
  14. Remove the EBCM/BPMV assembly (1) from the BPMV bracket.
  15. Remove and discard the 4 EBCM to BPMV screws.
    16. Fig 3: View Of EBCM & BPMV
    GM772017Courtesy of GENERAL MOTORS CORP.
  16. Clean the surface of the EBCM/BPMV assembly.
  17. Remove the EBCM (1) from the BPMV (2).
scientia non olet · About LEMON Manuals