Installation Procedure
WARNING: This page is about a different car, the 2007 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Route the mirror wiring harness through the hole in the mirror patch.
- Seat the grommet (2) into the hole in the door frame.
- Install the mirror (1) into the door frame.
- Install the mirror fasteners in the following sequence:
Tighten:
- Tighten the top mirror fastener (4) to 9 N.m (80 lb in).
- Tighten the forward mirror fastener (5) to 9 N.m (80 lb in).
- Tighten the rear, lower mirror fastener (6) to 9 N.m (80 lb in).
- Connect the power mirror electrical connector (3).
- Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.