Repair Verification
- Lower the EVAP purge canister to gain access to the EVAP vent inlet, and seal it, using a suitable plug or a plug from the J 41413-300 . See Special Tools .
- Turn the nitrogen/smoke valve on the J 41413-200 to nitrogen. See Special Tools .
- Use the remote switch to activate the J 41413-200 and pressurize the fuel tank with nitrogen to 5 in H20. See Special Tools .
- While observing the FTP sensor parameter with a scan tool, remove the EVAP vent valve plug.
- Verify the FTP Sensor parameter is 0 in H2O.
IMPORTANT:
DO NOT exceed the specified value in this step. Exceeding the specified value may produce incorrect test results.