LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> DTS 4.6 9 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 4.6L - Introduction (2 Of 2) >> Repair Instructions >> Fuel Rail Assembly Replacement >> Removal Procedure

Removal Procedure

NOTE:
  • Remove the fuel rail assembly carefully in order to prevent damage to the injector electrical connector terminals and the injector spray tips. Support the fuel rail after the fuel rail is removed in order to avoid damaging the fuel rail components.
  • Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering open pipes and passages.
  1. Relieve the fuel system pressure. Refer to the Fuel Pressure Relief Procedure .
  2. Clean the fuel rail assembly with a spray type engine cleaner, GM X-30A or equivalent, if necessary. Follow the package instructions. Do not soak the fuel rail in liquid cleaning solvent.
    3. Fig 1: Fuel Feed Pipe Quick Connect Fitting From Fuel Rail
    GM1662130Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the fuel feed pipe quick connect fitting from the fuel rail. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
    4. Fig 2: PCV Air Tube
    GM1661022Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the positive crankcase ventilation (PCV) air tube quick connect fitting from the camshaft cover. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    5. Fig 3: Surge Tank Inlet Pipe Hose
    GM1662131Courtesy of GENERAL MOTORS CORP.
  5. Reposition the surge tank inlet pipe hose clamp at the surge tank.
  6. Remove the surge tank inlet pipe hose from the surge tank.
    7. Fig 4: Surge Tank Inlet Pipe Hose
    GM1662132Courtesy of GENERAL MOTORS CORP.
  7. Reposition the surge tank inlet pipe hose clamp at the engine fitting.
  8. Remove the surge tank inlet pipe hose from the engine fitting.
    9. Fig 5: Surge Tank Inlet Pipe
    GM1662133Courtesy of GENERAL MOTORS CORP.
  9. Remove the surge tank inlet pipe nuts.
  10. Remove the surge tank inlet pipe from the fuel rail studs.
    11. Fig 6: Starter Solenoid Cable
    GM1665457Courtesy of GENERAL MOTORS CORP.
  11. Disconnect the engine harness electrical connector (1) from the starter solenoid cable electrical connector.
    12. Fig 7: Engine Harness Electrical Connectors From Front Fuel Injectors
    GM1662118Courtesy of GENERAL MOTORS CORP.
  12. Disconnect the engine harness electrical connectors (3) from the front fuel injectors.
    13. Fig 8: Engine Harness Electrical Connectors From Rear Fuel Injectors
    GM1662120Courtesy of GENERAL MOTORS CORP.
  13. Disconnect the engine harness electrical connectors (1) from the rear fuel injectors.
  14. Remove the engine harness clip (2) from the fuel rail stud.
  15. Lay the harness aside.
    16. Fig 9: Fuel Rail Bracket
    GM1662136Courtesy of GENERAL MOTORS CORP.
  16. Remove the fuel rail bracket retainer nut (2).
  17. Remove the fuel rail studs (1).
  18. Remove the fuel rail.
    19. Fig 10: Fuel Rail
    GM1672192Courtesy of GENERAL MOTORS CORP.
  19. Remove and discard the O-ring seals (4) from the spray tip end of each fuel injector.
  20. If replacing the fuel rail, remove the fuel injectors. Refer to Fuel Injector Replacement .
scientia non olet · About LEMON Manuals