Removal Procedure
Courtesy of GENERAL MOTORS CORP.
- Run the window to the full up position.
- Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door .
- Remove the water deflector. Refer to Water Deflector Replacement - Front Door .
- Tape the window in the full up position.
- Through the access holes in the inner door panel, loosen the window clamp nuts 4 revolutions.
- Connect the door trim panel wiring harness.
- Lower the window regulator 3/4 of the way down.
- Disconnect the electrical connector from the window regulator motor.
- Remove the window regulator bolts (1, 2, 3, 4, 5).
- Remove the window regulator from the door.