LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> STS 3.6 7 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Shift Interlock System >> Repair Instructions >> Automatic Transmission Shift Lock Actuator Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Shift Control Trim Plate
    GM891692Courtesy of GENERAL MOTORS CORP.
  1. Remove the shift control trim plate by lifting the rear of the trim plate up then pull the plate rearward in order to release the front retaining tabs.
  2. Remove the center console assembly. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console
    3. Fig 2: View Of Shift Indicator Lamp Sockets & Shift Lock Control Pigtail Wiring Harness Connector
    GM891687Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the wiring harness connector (3) from the shift lock control pigtail connector.
  4. Remove the shift indicator lamp sockets (1 and 2) from the shift indicator by rotating the lamp sockets one quarter turn. Note: it may be easier to remove the shift indicator in order to access the lamp sockets. Refer to Shift Indicator Replacement .
    5. Fig 3: Locating Shift Lock Actuator, Up/Down Switch & Screws
    GM891689Courtesy of GENERAL MOTORS CORP.
  5. Remove the two screws (1) from the shift lock actuator (2).
  6. Remove the shift lock actuator (2) from the shift control assembly.
  7. Remove the two screws (1) from the tap up/down switch (3).
  8. Remove the tap up/down switch (3) from the shift control assembly.
    9. Fig 4: View Of Shift Lock Actuator Wiring Harness
    GM892507Courtesy of GENERAL MOTORS CORP.
  9. Remove the shift lock actuator wiring harness from the shift control assembly.
scientia non olet · About LEMON Manuals