LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> SRX 3.6 7, AWD >> Repair and Diagnosis >> Brakes >> Antilock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of EBCM & BPMV
    GM772017Courtesy of GENERAL MOTORS CORP.
  1. Clean the seal surface of the BPMV (2).
  2. Install the EBCM (1) to the BPMV (2).
  3. Make sure that the internal pump motor connector (3) is installed into the new EBCM (1) prior to EBCM replacement.
    4. Fig 2: Installing EBCM To BPMV Screws
    GM782378Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Use New EBCM/BPMV screws after separating the EBCM from the BPMV.
  4. Install the 4 NEW screws connecting the EBCM to the BPMV.

    Tighten:  Tighten the screws in sequence (1-4) to 5 N.m (44 lb in).

    5. Fig 3: View Of EBCM, Electrical Connector & Connector Tab
    GM899235Courtesy of GENERAL MOTORS CORP.
    NOTE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.
  5. Connect the EBCM electrical connector (1) to the EBCM (3).
  6. Rotate the EBCM connector tab (2) rearward to the locked position.
  7. Install the washer solvent container bracket. Refer to Washer Solvent Container Replacement in Wipers/Washers Systems.
  8. Install the wheelhouse liner. Refer to Wheelhouse Liner Replacement - Front in Body Front End.
  9. Install the air deflector shield. Refer to Air Deflector Replacement - Front in Body Front End.
  10. Lower the vehicle.
  11. Use the scan tool in order to clear the DTCs.
  12. Perform the ABS Diagnostic System Check. Refer to Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals