Installation Procedure
- Install the shock absorber. Insert the stem through the hole in the shock bracket on the frame.
- Align the shock absorber with the mounting holes in the lower control arm, 15 Series.
- Align the shock absorber with the mounting holes in the lower control arm, 25/35 Series.
- Install the shock absorber bolt (2) to the lower control arm.
- Install the shock absorber nut (3) to the bolt.
Tighten: Tighten the nut to 80 N.m (59 lb ft).
- Install the upper insulator to the shock absorber.
- Install the nut to the tenon end. Do not tighten the nut.
- Connect the ESC link rod to the sensor, if equipped. Refer to Front Position Sensor Link Assembly Replacement - Electronic Suspension in Electronic Suspension Control.
- Remove the safety stands.
- Lower the vehicle.
- Hold the tenon end with a wrench while torquing the nut.
Tighten: Tighten the nut to 20 N.m (15 lb ft).
- Dispose of the shock absorber. Refer to Shock Absorber Disposal .
Fig 1: Removing/Installing The Shock Absorber Mounting Bolt At The Lower Control Arm (4WD, 15 Series)
Fig 2: Removing/Installing The Shock Absorber Mounting Bolt At The Lower Control Arm (4WD, 25 Series)
NOTE:
Refer to Fastener Notice in Cautions and Notices.
IMPORTANT:
The upper insulators are substantially larger that the lower insulators. The upper insulator (1) must be installed above the shock mounting bracket on the frame. The plastic pilot ring (2) will assist the alignment of the isolators.