LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> CTS Base, 2.8 T, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Introduction & Repair Instructions >> Repair Instructions >> Floor Shift Control Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Shift Control Assembly
    GM891704Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control assembly to the tunnel reinforcement.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 4 nuts securing the shift control assembly to the tunnel reinforcement.

    Tighten:  Tighten the nuts to 12 N.m (106 lb in).

    3. Fig 2: View Of Shift Indicator Lamp Sockets & Shift Lock Control Pigtail Wiring Harness Connector
    GM891687Courtesy of GENERAL MOTORS CORP.
  3. Connect the wiring harness connector (3) to the shift lock control pigtail connector.
    4. Fig 3: View Of Shift Control Assembly Electrical Connector
    GM891701Courtesy of GENERAL MOTORS CORP.
  4. Install the electrical connector (1) to the shift control assembly.
    5. Fig 4: View Of Shift Control Trim Plate
    GM891692Courtesy of GENERAL MOTORS CORP.
  5. Install the center console assembly. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console
  6. Install the shift control trim plate by inserting the front retaining tabs to the console. Press down on the rear of the trim plate to engage the rear retaining tabs.
  7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    8. Fig 5: View Of Shift Control Linkage Rod & Adjustment Nut
    GM830370Courtesy of GENERAL MOTORS CORP.
  8. Connect the shift control linkage rod to the shift control assembly.
  9. Install the shift control linkage adjustment nut finger tight.
  10. Adjust the shift control linkage. Refer to Shift Control Linkage Adjustment .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals