LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> CTS Base, 2.8 T, Automatic >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Steering Wheel And Steering Column >> Repair Instructions >> Ignition Switch Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Identifying Key Alarm Connector At Ignition Lock Cylinder Case
    GM306267Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system.
  2. Remove the theft deterrent control module. Refer to Theft Deterrent Control Module Replacement in Theft Deterrent.
  3. Rotate the key alarm connector (1) 90 degrees.
  4. Gently pull the key alarm connector (1) out of the ignition lock cylinder case assembly (2).
    5. Fig 2: Identifying Ignition Switch, Electronic Lock Module & J 42759
    GM664261Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the connector from the ignition switch assembly.
  6. Remove the wires encased in the ignition switch clip (located on the side of the ignition switch).
  7. Remove the ignition switch assembly (2) using J 42759 .
scientia non olet · About LEMON Manuals