Installation Procedure

Fig 1: View Of Ignition Lock Cylinder Case Assembly & Screws

Courtesy of GENERAL MOTORS CORP.

Align the ignition lock cylinder case assembly (1) with the steering column tilt head assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Secure the ignition lock cylinder case assembly (1) to the steering column using 3 pan head tapping screws (2).
Tighten: Tighten the screws to 7 N.m (62 lb in).
Install the ignition switch assembly. Refer to Ignition Switch Replacement .
Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
Install the theft deterrent control module. Refer to Theft Deterrent Control Module Replacement in Theft Deterrent.
Install the turn signal cancel cam and upper bearing. Refer to Turn Signal Cancel Cam and Upper Bearing Inner Race Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.