Installation Procedure

Fig 1: View Of Brake Fluid Pressure Sensor Connector & Nuts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Place the BPMV in the bracket and tighten the two insulator nuts.
Tighten: Tighten the nuts to 12 N.m (106 lb in).

Fig 2: View Of Brake Pipe Locations

Courtesy of GENERAL MOTORS CORP.

Connect the brake pipes that enter the BPMV from the front and rear calipers (1).
Tighten: Tighten to 16 N.m (12 lb ft).

Fig 3: View Of Master Cylinder

Courtesy of GENERAL MOTORS CORP.

Connect the brake pipes that enter the BPMV from the master cylinder (1).
Tighten: Tighten to 16 N.m (12 lb ft).
Install the belt tensioner. Refer to Drive Belt Tensioner Replacement in Engine Mechanical - 4.6L (LH2).
Connect the upper radiator hose. Refer to Radiator Hose Replacement - Inlet in Engine Cooling.

Fig 4: View Of Surge Tank Inlet Hose

Courtesy of GENERAL MOTORS CORP.

Connect the surge tank inlet hose. Refer to Surge Tank Hose/Pipe Replacement - Inlet in Engine Cooling.
Install the air inlet duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls - 4.6L (LH2).
Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 4.6L (LH2).
Fill the coolant system. Refer to Draining and Filling Cooling System in Engine Cooling.
Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) in Hydraulic Brakes.