Installation Procedure

Fig 1: View Of Radio Receiver Coaxial & Electrical Leads

Courtesy of GENERAL MOTORS CORP.

Position the digital radio receiver to the vehicle and connect the coaxial and the electrical leads to the receiver.

Fig 2: View Of Digital Radio Receiver & Nuts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the receiver to the mounting bracket and install 3 retaining nuts.
Tighten: Tighten the nuts to 9 N.m (80 lb in).
Remove the rear compartment stowage trim. Refer to Trim Assembly Replacement - Rear Compartment Floor Panel Stowage in Interior Trim.
Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .