LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> Seville >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Front End Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove any dirt, grease, or other impurities from the mounting surface.
    2. Fig 1: View Of Inflatable Restraint Front End Sensor & Components
    GM709876Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the inflatable restraint front end discriminating sensor (1) horizontally into the key hole slot (2) located in the lower tie bar.

    Point the arrow on the sensor toward the front of the vehicle.

    Tighten:  Tighten the fastener (3) to 9 N.m (80 lb in).

  3. Connect the inflatable restraint front end discriminating sensor harness wiring connector (4) to the inflatable restraint front end discriminating sensor (1).
  4. Install the CPA (5) to the inflatable restraint front end discriminating sensor wiring harness connector (4).
  5. Install the front air deflector. Refer to Air Deflector Replacement - Front in Body Front End.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 1 .
scientia non olet · About LEMON Manuals