Removal Procedure
- Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door .
- Remove the door module. Refer to Door Control Module Replacement .
- Remove the water deflector. Refer to Water Deflector Replacement - Front Door .
- Remove the inner belt molding. Refer to Sealing Strip Replacement - Front Door Window Belt Inner .
- Reconnect the power window switch and module.
- Raise the window to the full-up position.
- Tape the window in place.
- Loosen the window clamp attachment fasteners four revolutions.
- Lower the regulator clamps (2) to the full down position.
- Remove the window from the door in the following order:
- While supporting the window through the access hole of the inner panel, remove the tape holding the window up.
- Lower the window slightly.
- Tilt the window downward at the front.
- Pull upward on the rear edge of the window.
- Pull the window up and out of the door from the outer side of the window opening.
IMPORTANT:
This vehicle is equipped with express up, torque sensitive window on the front door windows.
When the battery or the power has been removed from the front door module, the front door module will need to be reprogrammed after power is restored and all repairs are completed.
When the battery or the power has been removed from the front door module, the front door module will need to be reprogrammed after power is restored and all repairs are completed.
CAUTION:
Refer to Express Window Down Caution
in Cautions and Notices.
CAUTION:
Refer to Glass and Sheet Metal Handling Caution in Cautions and Notices.