LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> Seville >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Back Frame Replacement - Front >> Installation Procedure

Installation Procedure

    Fig 1: View of Seat Back to Recliner Fasteners
    GM547146Courtesy of GENERAL MOTORS CORP.
  1. Slide the seat back straight down into recliner assembly and align the bolt holes.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install 4 seat back frame bolts.

    Tighten:  Tighten the seat back frame bolts to 28 N.m (21 lb ft).

    3. Fig 2: View of Heated Seat Cushion Electrical Connector
    GM295170Courtesy of GENERAL MOTORS CORP.
  3. Connect the heated seat electrical connectors, if equipped with KA1.
  4. Connect the air lines for the adaptive lumbar, if equipped with AC9.
    5. Fig 3: View of Lumber Electrical Connector
    GM295159Courtesy of GENERAL MOTORS CORP.
  5. Connect the lumbar electrical connector.
  6. Connect the side impact air bag electrical connector.
  7. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
  8. Install the front seat belt shoulder retractor. Refer to Seat Belt Replacement - Driver or Passenger in Seat Belts.
    9. Fig 4: View of Rear Seat Post Finish Cover
    GM547120Courtesy of GENERAL MOTORS CORP.
  9. Install the rear seat belt post finish cover.
  10. Install the rear seat belt post finish cover fasteners.

    Tighten:  Tighten the fasteners fully driven, seated, but not stripped.

  11. Install the seat back trim cover. Refer to Seat Back Panel Replacement - Front .
  12. Install the front bucket seat into the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals