LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> SRX 3.6 7, AWD >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Relearn >> Using Scan Tool

Using Scan Tool

  1. Install a scan tool. Turn ignition switch to ON position, with engine off. Apply parking brake.
    NOTE: If learn mode cannot be enabled, TPM system is not enabled in DIM. See appropriate manufacturer service information.
  2. Using scan tool, select "SPECIAL FUNCTIONS".
  3. Select "SENSOR LEARN MODE ENABLE", and press ENTER key.
  4. Press ON soft key. A horn chirp will sound, indicating the learn mode has been enabled.
    WARNING: Overinflating tires may cause personal injury or damage to the tires and wheels. When increasing tire pressure, DO NOT exceed the maximum inflation pressure as noted on the tire sidewall.
    NOTE: If a horn chirp does not sound after 35 seconds for any of the 4 sensors, turn OFF ignition to exit the learn mode and repeat the procedure from step  2.
  5. Starting with left front tire, increase or decrease pressure for 5-8 seconds, or until a horn chirp sounds. The horn chirp may occur before the 5-8 second pressure increase/decrease time period has been reached, or up to 30 seconds after the 5-8 second pressure increase/decrease time period has been reached.
  6. After horn chirp has sounded, proceed as in step  5 for the next 3 sensors in the following order: right front, right rear and left rear.
  7. After left rear sensor has been learned, a double horn chirp will sound, indicating all 4 sensor IDs have been learned. Turn ignition switch to OFF position. Adjust all tire pressures to specification.
scientia non olet · About LEMON Manuals