LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> Escalade EXT >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Shock Absorber Replacement >> Installation Procedure

Installation Procedure

  1. Install the shock absorber. Insert the stem through the hole in the shock bracket on the frame.
    2. Fig 1: Shock Absorber & Mounting Bolt (15 Series)
    GM348386Courtesy of GENERAL MOTORS CORP.
  2. Align the shock absorber with the mounting holes in the lower control arm, 15 Series.
    3. Fig 2: Shock Absorber & Mounting Bolt (25/35 Series)
    GM353965Courtesy of GENERAL MOTORS CORP.
  3. Align the shock absorber with the mounting holes in the lower control arm, 25/35 Series.
  4. Install the shock absorber bolt (2) to the lower control arm.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the shock absorber nut (3) to the bolt.

    Tighten:  Tighten the nut to 80 N.m (59 lb ft).

    6. Fig 3: Identifying Upper Insulator
    GM477707Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The upper insulators are substantially larger that the lower insulators. The upper insulator (1) must be installed above the shock mounting bracket on the frame. The plastic pilot ring (2) will assist the alignment of the isolators.
  6. Install the upper insulator to the shock absorber.
  7. Install the nut to the tennon end. Do not tighten the nut.
  8. Connect the ESC link rod to the sensor, if equipped. Refer to Front Position Sensor Link Assembly Replacement - Electronic Suspension in Electronic Suspension Control.
  9. Remove the safety stands.
  10. Lower the vehicle.
  11. Hold the tennon end with a wrench while torquing the nut.

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

  12. Dispose of the shock absorber. Refer to Shock Absorber Disposal .
scientia non olet · About LEMON Manuals