LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 416 (Transfer Case - NVG 246-NP8) >> Repair Instructions >> Encoder Motor Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: For ease of reassembly, shift the transfer case to Neutral prior to removing any components.
  1. Remove the encoder motor. Refer to Transfer Case Encoder Motor Replacement .
  2. Place the encoder motor on a clean work bench.
  3. Remove and discard 2 screws (2) from the motor cover.
  4. Remove and discard 2 screws (1) from the casting.
    5. Fig 1: View Of Motor Cover Screws & Casting Screws
    GM1341854Courtesy of GENERAL MOTORS CORP.
  5. Remove the cover.
  6. Remove and save the shim on the output gear.
  7. Remove and discard the orange rubber seal from the cover.
  8. Remove the output gear (1).
    9. Fig 2: View Of Output Gear
    GM1361842Courtesy of GENERAL MOTORS CORP.
  9. Disassemble the harness connector (1) from the encoder.
    10. Fig 3: View Of Encoder Harness Connector
    GM1361873Courtesy of GENERAL MOTORS CORP.
  10. Remove the encoder from the output shaft using a flat-tipped screwdriver.
scientia non olet · About LEMON Manuals