LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> Escalade EXT >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Entertainment System >> Repair Instructions >> Receiver Replacement - Digital Radio >> Installation Procedure

Installation Procedure

  1. Connect the coaxial cables.
  2. Connect the wire connector.
  3. Install the receiver and bracket assembly to the I/P.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the 2 retaining screws (1).

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

    5. Fig 1: Connecting Wire Connector & Installing Receiver/Bracket Assembly Screws
    GM854856Courtesy of GENERAL MOTORS CORP.
  5. Install the right side junction block to the I/P. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Right in Wiring Systems.
  6. Close the I/P compartment door.
  7. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
scientia non olet · About LEMON Manuals