Removal Procedure
IMPORTANT:
- Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
- Always route the replacement cable the same way as the original cable.
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
- Disconnect the battery positive cable (1) from the battery.
- Remove the nut (1) securing the battery positive cable to the rear fuse block.
- Remove the interior trim moldings. Refer to Garnish Molding Replacement - Center Pillar (Standard) or Garnish Molding Replacement - Center Pillar (WC2, WC8) in Interior Trim to expose the positive battery cable.
- Remove the right closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages, and Console.
- Remove the battery cable retainers (2) from the rocker panel area.
- Remove the remote positive terminal nut (1) and disconnect the battery positive cable from the underhood fuse block (2).
- Remove the surge tank. Refer to Surge Tank Replacement in Engine Cooling.
- Disconnect the battery cable retainer from the body side rail.
- Unseat the battery cable grommet (2) from the cowl panel (3).
- Carefully remove the battery cable (1) from the vehicle by pulling the cable through the cowl panel (3) and out of the vehicle.