LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.6L - Introduction >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Crankshaft Position Sensor
    GM1311144Courtesy of GENERAL MOTORS CORP.
  1. Install the crankshaft position sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the crankshaft position sensor bolt.

    Tighten:  Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).

    3. Fig 2: Connecting CKP Electrical Connector
    GM887868Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP electrical connector (3).
  4. Install the wiring harness heat shield to the oil level indicator tube.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals