LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Repair Instructions >> Seat Belt Replacement - Front >> Installation Procedure

Installation Procedure

  1. Ensure that the seat belt is not twisted before installing the retractor.
    2. Fig 1: Seat Belt To Lower Retaining Nut & Mounting Stud
    GM792277Courtesy of GENERAL MOTORS CORP.
  2. Install the seat belt (2) to the mounting stud.

    Ensure that the anti-rotation tab on the seat belt is located properly in the seat frame before tightening the retaining nut.

    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the retaining nut.

    Tighten:  Tighten the nut to 42 N.m (31 lb ft).

  4. Position the seat belt over the roller assembly.

    Ensure that the seat belt is not twisted.

    5. Fig 2: Seat Belt Retractor To Seat Frame
    GM719067Courtesy of GENERAL MOTORS CORP.
  5. Install the seat belt retractor.

    Ensure that the anti-rotation tab on the seat belt retractor is located properly on the seat frame before tightening the retractor fastener.

  6. Install the retaining bolt.

    Tighten:  Tighten the bolt to 26 N.m (19 lb ft).

  7. Install the roller assembly cover.
  8. Install the roller assembly screws.

    Tighten:  Tighten the fasteners to 5 N.m (44 lb in).

  9. Ensure proper operation of the seat belt retractor.
  10. Reinstall the seat back cover. Refer to Seat Back Cover and Pad Replacement - Front in Seats.
  11. Install the front seat. Refer to Seat Replacement - Bucket in Seats.
  12. Confirm proper operation of the seat belt retractors.
scientia non olet · About LEMON Manuals