Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bracket on the height sensor with four nuts.
Tighten: Tighten the four nuts to 3 N.m (26 lb in).
Install the height sensor with the bracket on the vehicle with two bolts.
Tighten: Tighten the two bolts to 6 N.m (54 lb in).

Fig 1: Identifying Height Sensor Bracket & Nuts

Courtesy of GENERAL MOTORS CORP.

Connect the link to the height sensor actuating arm and the suspension control arm.
Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Adjust the height sensor. Refer to Automatic Level Control Sensor Adjustment .