LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> Seville SLS >> Repair and Diagnosis >> External Pages >> Different car >> Section 534 (Suspension Control System - Suspension Leveling) >> Repair Instructions >> Automatic Level Control Air Compressor Head Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air compressor assembly from the vehicle. Refer to Air Compressor Replacement .
    2. Fig 1: View Of Air Compressor & Bolts
    GM344303Courtesy of GENERAL MOTORS CORP.
  2. Remove the air compressor connector from the connector anchor (slide the air compressor connector away from the air compressor and off of the anchor).
  3. Remove the 3 bolts and the heat shield from the air compressor bracket.
  4. Remove the air dryer. Refer to Automatic Level Control Air Dryer Replacement .
    5. Fig 2: Exploded View of Harness Tie
    GM227999Courtesy of GENERAL MOTORS CORP.
  5. Cut the harness tie.
  6. Remove the bolt and the harness tie.
    7. IMPORTANT: Note the wire colors and the terminal numbers to ensure correct assembly.
  7. Remove the 2 harness ties and the wrap from the wires.
    8. Fig 3: Identifying Air Compressor Head to Assembly Head Bolts
    GM228003Courtesy of GENERAL MOTORS CORP.
  8. Remove 2 wire terminals from the air compressor connector.
  9. Remove the air hose from the air compressor head.
  10. Remove the 3 head bolts and the air compressor head from the air compressor assembly.
  11. Remove the gasket from the air compressor head or the air compressor assembly.
scientia non olet · About LEMON Manuals