Removal Procedure
WARNING: This page is about a different car, the 2004 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
- Insert a flat bladed tool under the rear edge of the front window switch plate.
- Push the tool firmly towards the switch plate, in order to disengage the retainer.
- Lift up on the rear of the switch plate in order to remove the switch assembly from the door trim panel.
- Disconnect the electrical connectors.
- Remove the switch assembly.
- Remove the appropriate switch from the switch plate by disengaging the side snap walls with small flat bladed tool.
NOTE:
The retainer clip must be fully disengaged before the switch plate is removed. Otherwise, damage to the switch plate could result.