LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2003 >> Seville SLS >> Repair and Diagnosis >> External Pages >> Different car >> Section 479 (Entertainment System) >> Repair Instructions >> Receiver Replacement - Digital Radio >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Digital Radio Receiver Bracket Nuts
    GM800462Courtesy of GENERAL MOTORS CORP.
  1. Install the digital radio receiver to the receiver bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts (1) to secure the receiver to the bracket.

    Tighten:  Tighten the nuts to 7 N.m (62 lb in).

    3. Fig 2: View of Digital Receiver, Electrical Connector, & Antenna Connector
    GM827604Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector (3) to the digital receiver (1).
  4. Engage the CPA electrical connector.
  5. Connect the antenna connector (2) to the digital receiver (1).
  6. If removed, install the mounting bolts to the bracket to a depth of 3-4 threads.
    7. Fig 3: Identifying Digital Receiver Mounting Bolts
    GM827598Courtesy of GENERAL MOTORS CORP.
  7. Align the receiver and bracket assembly to the keyhole slots in the rear reinforcement, with the electrical connection end towards the rear compartment floor.
  8. Install the receiver mounting bolts (1) to the keyhole slots. Slide the receiver and the bracket down.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  9. Install the left rear compartment trim panel. Refer to Compartment Side Trim Replacement - LH Rear in Body Rear End.
  10. Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
scientia non olet · About LEMON Manuals